Start With The Space, Not The Unit
A good install begins with where the heater will sit. The room decides which fuel you can use, how the flue or exhaust runs and how a leak drains. Picking a model first often forces expensive changes later.
Garage or basement utility room
Most Lehi homes put the heater here. Floor drains, venting paths and gas lines are usually close by.
Closet or finished space
A leak here can reach flooring and drywall fast, so a drain pan and a safe discharge path are essential.
New construction
We coordinate with the builder so rough in, gas and venting match the model before walls close.
Relocation or upgrade
Moving a unit changes pipe runs and venting, so plan extra time and a written scope.
What A Complete Install Includes
Items we confirm on every install
- Strapping in the upper and lower thirds of the tank where Utah rules call for it
- A drain pan and pan drain line where a leak could damage finished space
- A relief valve with a safe discharge pipe
- An expansion tank on closed systems when needed
- Shutoff valves at the inlet and gas supply
- A final test with water running and the unit firing
Each item protects something specific. Strapping keeps the tank upright if the ground moves, a pan catches slow leaks, and the expansion tank protects fittings from pressure swings. We list each one in the scope so nothing is a surprise.
Fuel ChoicesGas, Electric Or Hybrid
| Fuel | Needs | Notes |
|---|---|---|
| Natural gas | Gas line, venting and combustion air | Widely used where gas service is available, check the line size for tankless units |
| Electric | A dedicated circuit sized for the tank | Simple venting, check panel capacity first |
| Hybrid heat pump | Open air space, condensate drain and a circuit | Works best in roomy garages or basements |
If you want to go tankless, read the tankless page first because the gas and venting needs are larger. For a leaking tank that cannot wait, call about water heater replacement instead.
ProcessThe Install Visit
Walk through
We review the space, gas or electric supply and venting path.
Scope and price
You get a written scope and a clear price before work starts.
Install
The tank is set, connected, vented and strapped, with shutoffs and a pan.
Start up
We purge air, test for leaks and confirm temperature at a tap.
Permits And Inspections In Lehi
Lehi Building and Inspections handles permits through an online portal and schedules inspections by phone with 24 hours notice. The office is at 153 N 100 E and the number is (385) 201-1035. Permit requirements depend on the job, so we confirm what applies before the visit and tell you what to expect.
Utah also adds statewide amendments to the plumbing code that address water heater strapping and pan drains. We install to those rules and explain what was done when the job ends.
Want An Install Date On The Calendar?
Call and we will talk through the space, the fuel and a scheduled visit.
Pricing For A New Install
Water heater work in Utah follows the International Plumbing Code (IPC) with state amendments. Those amendments cover details such as strapping the tank in its upper and lower thirds and draining a pan to a safe location.
FAQsWater Heater Installation Questions
Planned installs are booked around your calendar, and same-day appointments are offered when available. For new construction, call as soon as framing is complete so rough in matches the model.
We confirm what the job needs with Lehi Building and Inspections and explain it to you before the visit. The city lists permits through an online portal and inspections by phone.
Yes. Relocations change pipe runs, venting and sometimes gas or electric supply, so expect a longer scope and a written plan before work starts.
Household size and peak use set the size. The plumber asks about showers, tubs and appliances and recommends a size, and you choose.
Utah rules call for pans in many places where a leak could damage the floor or finished space below. The plumber confirms what applies to your install.
Call and describe the unit. We will tell you whether it fits the space and what the install involves before you commit.

